Betafpv VR03 FPV Goggles divercity mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A diversity modification of cheap FPV goggles by adding a separate receiver, the Eachine Pro58 RX.
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 54
- Wydruki
- 1
- Wyświetlenia
- 1136
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
I used the popular Eachine PRO58 RX Diversity 40CH receiver for this modification. The goal was to keep the receiver in the goggles functional while having the option to turn on an external receiver if needed. The external receiver connects via three wires: GND, +5V, and video out.
I am providing the connection diagram. Please note that on the goggles' board, you need to cut the power trace to the built-in receiver module (as shown in the diagram). This requires caution since the board is multi-layered; try not to damage the internal layers.
The external receiver is installed in place of the front cap, and I printed it using ABS. Please pay attention to the correct orientation of the model (separate screenshot in the gallery). You may need to slightly file the part for it to fit into the grooves.
In my design, I used PBS-9, PBS-4, and PLS-4 connectors for ease of assembly. The PBS-9 is connected to the PRO58 contacts, which allows you to replace the receiver if necessary. The PBS-9 connector and the switch are glued to the 3D model using adhesive.
I am not responsible for any damage to your goggles. You undertake everything at your own risk.