Flsun SR Active Chamber Heater
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple low cost Active Chamber for enclosure Flsun SR
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 708
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Active chamber for my Enclosure Flsun Super racer:
https://www.printables.com/model/702303-flsun-sr-superracer-enclosure
Version2 for PTC up to 400W (My choice 220V 200W INSULATED)
https://es.aliexpress.com/item/1005007442989854.html
Mini heater Version:
https://es.aliexpress.com/item/1005005017277103.html
If it seems too little heat two units could be installed these mini heaters (only 50W) will heat up faster.
To install, cut one of the acrylic panels about 18cm
Use thermal insulation fabric in the direct hot air area and internal Top printer to protect the electronics and not lose heat inside the enclosure. It is advisable to add extra ventilation to the electronics area.
I use temperature sensor inside the enclosure with this temperature controller (24V):
https://es.aliexpress.com/item/1005001336008467.html
Do not exceed 70C, may damage components.
Print in ABS, ASA, PC or Nylon (PLA or PETG will soften with heat)
Print Setting:
0.2 Layer
20% Infill
3 wall 3 Top 3 Bottom
Supports Yes