Printable DSLR Mirrorless Camera Tripod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was not happy with what else was available to print so I designed and made my own. IMO It's much better and printed…
- Ocena
- 4 / 5
- Polubienia
- 28
- Pobrania
- 83
- Wydruki
- 2
- Wyświetlenia
- 648
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
I was not happy with what else was available to print so I designed and made my own. IMO It's much better and printed in about 3hrs on a Bambu A1 mini. Pictured with a 375g body and a 300gr lens.
Base: 0.16, 2.4mm walls, 20% infill
Legs: 0.08-0.2 adaptive, 3 walls, 15% infill PLA if you don't intend to let it bake in the sun.
Key Features:
- Sits flat even when back legs are removed
- 46.2* of tilt available
- Rigid mechanical lock at full extents of range
- Lightweight
- Designed around FDM print "limitations"
- Only 4 screws needed! 1x 1/4-20x 1.75" 2x 1/4-20x 3/4" 1x 1/4-20x 1/2" 2x 1/4-20 Hex nuts (You could print these as well or modify the base to be tapped. I included a step file. Remove the hex and reduce the thru hole to be .205") -You can buy 4x 1.75" ones and trim them to length via dremel or hacksaw -You can also use 3x D-ring tripod screws if you'd like to make this tool-less.
In my province, it's easiest to buy a 5 pack of 2." 'Stove bolts" and modify them. They come with the hex nuts.
Print Settings
Printer Brand:
Bambu Lab
Printer:
A1 Mini
**Rafts:**
No
Supports:
No
Category: Camera