1 / 2
Tamiya DT-01 -- Front damper stay (including body mount) — zdjęcie 1
1 / 2

Tamiya DT-01 -- Front damper stay (including body mount)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A replacement for the front damper stay on a DT-01.

Ocena
0 / 5
Polubienia
7
Pobrania
57
Wydruki
0
Wyświetlenia
192
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

This is my printable replacement for the front damper stay on the Tamiya DT-01, labeled as the front body mount in the manual, as it includes that. I currently believe there to be only one variant, unlike the rear body mount, as used on all releases.

I created this file as I see it as a potential weak point, especially as it was already broken on one of my DT-01 and as the plastic ages, more will crack. Luckily it's a separate part. My design should be stronger than the original, and fits as the original did.

Printing

I recommend printing this in PETG, with a layer height l ≤ 0.2mm with supports, oriented with the back of the damper stay on the print bed. The pictured print is a prototype, so lacks some of the cleanup and lower clip.

Post Print

After removing supports, the part should fit as the original did. The body pin holes can be cleaned up with 1.5mm drill bit if they're a bit tight, but printed should be around 1/16 in (1.59mm).

Tagi