Pulp Fiction pinball hole protectors

Print the Roll scene "curvey" side down. I used a textured plate for this. The Briefcase squarish side down. Pawn shop can be done with either flat plate or textured. TPU of course. I used an piece of shrink tubing with s small piece of an old switch to extend the Roll scene switch, but added a switch extender as noted below.  I printed these as shown in the picture above, please do the same. I've found that removing the supports while the print is still hot on the build plate makes them way easier to remove. Try doing this. I used pla as a support filament, but if you don't have a multi-extruder machine, remove asap after printing.
I've added a switch extender that was requested and is a remake added to this model(Thingiverse). I've changed it slightly to allow the ball to "roll" over the lever. The curvature is not symetric, one side has more of a curve to it as it sits at an angle. Install it with the dot side down. You may have to “open” the slot a bit with a screwdriver. Regaring the installation of the Briefcase protector, the protector aligns the center of the hole (ie playfield) to the center of the VUK. If the VUK wasn't centered perfectly when it was installed, as some were, you may have to fill and redrill the mounting holes for it. Mine was perfect and I had no issue, but this can be an issue. ymmv.