Gantry filament guide and runout sensor mount - Sovol SV07 plus
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Updated 26/4-25: Kit to remove the spool of the gantry. Guides the filament via a bowden/PTFE tube to the runout sensor.
- Ocena
- 4 / 5
- Polubienia
- 16
- Pobrania
- 53
- Wydruki
- 1
- Wyświetlenia
- 421
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Updated 26/4-25: New version V7 with sleeker design and threads for 6 mm PC4-M6 bowden couples as well as PC4-M10. Also slightly redesigned runout sensor mount to reduce sag.
A little kit i put together to remove the spool of the gantry and print directly from a drybox etc.
SV07 Gantry Bowden Guide is a guide that fits an PC4-M10 tube coupler. Threads are printed too. Locks in via the 2 screw holes on the top of the beam. Prints without supports.
Gantry guide & runout mount locks in to the mount that the spoolholder ususally uses. It also holds the filament runout sensor and guides the filament into the sensor. Note: to hold the sensor you need an M3 heat insert. Add supports on the print.