Filament Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is filament spool holder which is based on the DELACK filament spool holder.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 1
- Wyświetlenia
- 140
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is filament spool holder based on the DELACK filament holder. Roller span can be adjusted to fit any spool width. Rollers slide back and forth on the rod.
All parts are made from PETG except the rollers which are made from TPU (95A).
There are three roller options. Original roller is a one piece design and requires support material which can be hard to remove. Roller2 and Large Roller are a two piece design requiring no support material. For roller2 and Large Roller, insert bushing in SideB and then SideB into SideA.
Bill of material
- 2x Base/Sides
- 1x Hex Insert
- 3x Splice sticks
- 4x Rollers
- 4x 5x16x8mm bearings for roller2
- 4x 7x22x8mm bearing for larger roller (These are the DELACK bearings)
- 4x rubber feet (These are from the DELACK enclosure I purchased.) Any rubber grommet that fits a 10mm hole with flange of 3mm will work.
- 2x 8x115.4mm stainless steel rods. Tapped on each end for M3x0.5x10mm threads. Rods must be 8 +.00/-.05mm for bearings to fit.
- 4x M3x0.5x10mm socket head screws