Nevermore Mount for SV08
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple mount for a Nevermore Micro V6 to go inside the enclosure of my SV08 (or any printer really)
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 654
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
As I'm printing ASA I want a filtration system inside my Sovol SV08. There's not really anywhere to fit a Nevermore Micro v6 at the base but this mount can be installed into a top hat at the top of the printer. You could always use it with other printers if you want.
I made this to work with the 2020 plenum part. It replaces the standard 2020 frame connector part. You can use the same M3 nut and bolt you'd get in a kit to connect the mount to the Nevermore.
You'll then need 2x M3 heat set inserts and some extra M3 screws of an appropriate length. I am using M3x16 with some holes drilled through Nadir's double height top hat. The design can be used as a drilling template prior to installing the heat sets (or just print 2).
Install photos to come later..