Creality K2 Plus Lead Screw Debris Guards with Taper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Leadscrew Guards for the Creality K2 Plus at the bottom of the enclosure for protection against debris buildup.
- Ocena
- 3,25 / 5
- Polubienia
- 121
- Pobrania
- 878
- Wydruki
- 3
- Wyświetlenia
- 2388
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I created these early on for two reasons; cleaning out filament debris from the small cavity surrounding the leadscrew rotation area at the bottom of the printer was tedious. As well if any instance of filament strands or dirt getting pulled into the bearing of the leadscrew motor (Pretty unlikely though).
I Printed these from ASA for heat resistance when using the heated chamber and the ease of support removal vs Nylon or PC. I suggest you do the same but if not just be mindful of having tuned supports.
If you have any comments please let me know. I made the tolerances kind of tight around the leadscrew and the dove-tails. As well, I put a 0.5mm clearance for the cover and the leadscrew OD, so if these spin with the leadscrew, just hold them down and move the bed up and down a few times to wear them in to stop spinning with the leadscrew.
Thanks and happy printing!