Dive Gear Express SPG Protective Boot 1.75" Face
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a TPU Filament protective boot printed in two halves. This fits the DGX 1.75" SPG only.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 109
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Protective boot/case for a Dive Gear Express SPG (1.75" face). See link for applicable gauge. low profile design that does not collect sea water on the hose attachment leading to corrosion like a traditional boot. Provides drop protection to back, sides, and partial glass face protection.
https://www.divegearexpress.com/dgx-white-face-premium-spg-naked
The print is in two pieces; one bottom and one top.
Install steps: 1) SPG must be removed from hose for installation. 2) slip hose attachment through 14mm hole on bottom print first and wiggle the SPG into the base. 3) slide hose attachment through 14mm hole in top half print and wiggle over the already installed bottom half.
Print in place without supports.
TPU flex, but other materials may work.
Scuba is a dangerous activity. Use this print at your own risk. Consider creating small hole in back for blow out.