10 inch Rack Shelf Drawers

• v1 vs v2 different read in change log below

• you need to print 1-3 to use as drawers 4-5 is optional

  1. rack shelf (rack mount)

  2. rack shelf backplate

  3. drawer

  4. drawer insert

  5. rack shelf top

• backplate

  • print separate from rack shelf so you can turn to normal network shelf if you decide not to use drawers

  • Back Cover Cable Pass Thought no need to flip side to print and can print without support (have some spaghetti), you can grab and print cover from 10 inch Blank Plate Mod Cable Pass Through if you want to cover 2 cable hole later

• drawer

  • Shelf Drawer with (G) can use drawers insert from

    • 6.5 inch Rack Shelf Drawers (white drawers photo)

    • gridfinity 3x3x4 or 3x4x4

• rack shelf top

  • require M3*(2-4.6mm) screws (spare HDD SSD mounting screws mostly come with motherboard

• if you put much heavy stuff and you use 3D printable rack by @Mauker you can print Support Rack in 3D printable rack - 10 inch Support Beam for Printable Skadis Mount

My print settings

• rack shelf

  • layer height: 0.2 

  • wall: 3

  • infill: 15%

• rack shelf backplate, drawers

  • same as above but wall 2

If you enjoy my work, please consider support at link in profile.

Change Log

• 2025/12/13

  • Add V2 Model 

    • 10 inch Shelf Drawer B (G) V2

  • Fix V2 Model (increase front edge 2mm)

    • 10 inch Shelf Drawer A (G) V2

    • 10 inch Shelf Drawer B V2

• 2025/10/26

  • Move old file to old v1 folder and add suffix V1

  • Add V2 Model 

    • V2 is redesign base on 6.5 inch version, it design by closed shelve in mind like lid not take space from above shelf 1-2mm anymore

    • most V2 file not work with any v1 version file except

      • V2 drawer can put in V1 rack shelf (rack mount)

    • V1 backplate work with V2  rack shelf (rack mount)

    • if you dont care about rackshelf top cover take space from above shelf then v1 file work better because when you stack each drawer it will not cause gap from each shelf like v2 (2mm gap)