Step-down gearing for Chassis 1/10 Adaptable - DKS-Basic
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reduces the gear ratio from 1:3 down to 1:8.95
- Ocena
- 5 / 5
- Polubienia
- 49
- Pobrania
- 234
- Wydruki
- 3
- Wyświetlenia
- 1681
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Summary:
After building a Robak 2 for my nephew using robaki's Reduction Gears, I was reminded of Duke Dok's chassis and my not-so-great decision to use a 3900KV motor.
This gear set is designed to reduce speed to approximately one-third. The additional bearings required are the same size as those already used on the rear of the original chassis. To accommodate printing inaccuracies and prevent binding, 0.4mm were added to the optimal center distance of the gears.
Thanks to Robaki for providing the STEP files for his design in the Robak Discord.
Hardware:
| Part | Size | Qty |
|---|---|---|
| Bearing | 6701, 12x18x4mm | 3 |
| Hex brass standoff | M3x20mm | 1 |
| Socket head cap screw | M3x10mm | 2 |
| M3x16mm | 4 | |
| M3x20mm | 2 | |
| Set screw | M3x3-4mm | 1 |
"Happy printing, and God bless, my friend."
— Bob Ross