Double Paper Towel Holder - using IKEA NEREBY
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keep the paper towels off the kitchen bench. Different lengths support larger rolls. Uses a cheap dowel from IKEA.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 88
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This simple design lifts the paper towels off your bench, saving space while keeping them close at hand.
Each side fastens into the cupboard underneath with a single screw, or you could use hot glue or similar if making holes is not an option.
To change the rolls, just push one link inwards to pop it off the bracket.
Build Instructions:
You will need:
- 1x IKEA Nereby 904.763.43, eg like this one.
Or 004.673.00 if you want a shorter rod for a single roll. - 2x screws, I used some IKEA spares but anything that fits should be fine.
Or glue. - 2x of the Link part.
Use Link-120mm for a standard size roll, or Link-150mm for a jumbo roll. - 2x of the Bracket part. One of the parts must be mirrored.
Printing:
Orient the Bracket so that the boss is facing upwards,
and the Link so that it is flat on the bed.
Default settings are fine, no supports needed.
Assembly:
- Calculate where the brackets must be mounted.
In my case, the brackets are aligned on the edges of a 60cm METOD cabinet.
- Hold each bracket in place with boss facing inwards, and fix with a screw or glue.
- Slide the links over the end of the NEREBY rod and hang them on the brackets.
Moving the links out a little bit on the dowel will help secure the holder.
Changing the Roll:
Push one link inward until it comes off the bracket, then take the rod down.
The links will slide easily off the end of the rod to allow changing the roll.