ERCF Bakside Mount for Creality K1 Max
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A new design of the mount for ERCF.
Use this instead of https://www.printables.com/model/920702-creality-k1-max-ercf-top-mount , if your lid riser interferes with it, or if you need better access to the lid.
The provided model is for the left side - mirror it in the slicer to print the right side. Regardless of which mount style you choose, a lid riser is absolutely 100% necessary for MMUs to function - or you might need to always print without a lid, like Creality suggests with their CFS kit.
Recommended lid riser with this style of the mount: https://www.printables.com/model/1113589-creality-k1-max-lid-riser-v3-frame-extension-kit
Every screw hole is intentionally made elongated, to allow some tolerances for installation.
Remove the screws from both top-back corners on the side panels and the bottom ones of the two on the same top corners on the back panel. Install 4 spacer wahsers into the screw holes in the side panels. Lightly tap your 2020 aluminum extrusions into the matching sockets. Then place the assembly against the matching corners of your printer, the spacer washers will help you align the brackets with the holes on the side panels. Do not load the assembly yet, as the alignment spacers will break off easily. Keep holding it with your hand and use 6 pcs M3x8 or M3x10 screws with washers on them to secure the mount? starting with the side panels. Don't tighten the side screws all the way until you've tightened the back screws. Then press both brackets together to fully insert the aluminum extrusions into the sockets, if they didn't go all the way in. Once secured, attach your ERCF to the mount.
IMPORTANT: Do not install it on the printer with ERCF already bolted to the mount! This is very likely damage your printer and/or the mount. The screws WILL NOT hold it unless all 6 of them are fully screwed in. Be sure to use washers, preferably wide ones.
UPD 08.04.2025: Reuploaded with K1C compatible screw placement. Replaced the tiny bosses for screw holes with spacer washers.