1 / 9
Auxiliary Monitor Desk Stand — zdjęcie 1
1 / 9

Auxiliary Monitor Desk Stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A desktop stand to support a lightweight portable monitor often used with laptops.

Ocena
0 / 5
Polubienia
0
Pobrania
7
Wydruki
0
Wyświetlenia
58
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This bracket will support a lightweight auxiliary monitor and is set at precisely 14° off verticle. I use it as an instrument panel monitor in my Flight Sim setup. Aircraft panels are traditionally vertical 0°, 7°, or 14° from vertical. Some gyro instruments need a wedge behind them if they aren’t set up for the panel angle. But I digress. You can print it with or without support. I did one of each, and they seem fine, but it might depend on your filament and printer capability. Put silicone bumpers in the divots on the bottom for a non-slip mount.

The base is 290 mm wide so you will need a printer that can hack that.

PLA, 0.24mm Layers, 3 Walls, 20% GYROID infil.

Tagi