Disc Detainer Pick
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Disc Detainer Pick handles used for picking front tensioned disc detainer locks (in photos equiped for abloy exec)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 197
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Front Tensioned Pick
use between 70-100% infill for best results
Uses #4-40 Hardware
Picking tips are made from ejector pins with 1.5mm shaft
Tension tips are made from 6mm od steel tubing
An indexing flat has been created at the back of the tension handle. It is difficult to see but it does help.
An indexing detent is also present in the picking handle however it may breaker during use. Tightening the screws on the pick handle should still hold the picking tip with enough friction.
The final print may need to have the pick tip holes drilled to final dimensions as some printers don't deal with small holes well.
A tighter ID on the tensioning bit may help with alignment. This design has some friction between parts. some amount of break-in can be expected. Ensuring that your ejector pin shaft isn't bent/curved will help with misalignment.