1 / 3
SV06 Runout Mount - Uses Original Hardware
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Moves the filament runout sensor to directly above the extruder, rather than on top of the gantry.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 78
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Move your filament sensor to directly above your extruder. This remixed model is designed to let you use the original hardware from your SV06 Plus.
printed with PLA at 0.15mm resolution
Steps:
- Remove the runout sensor from the spool holder on the gantry
- Remove the two M3 hex head screws that go horizontally through the sensor
- Discard the thin metal bracket, which contains the threads that originally held these two screws in-place
- Insert those two screws from the right side of the bracket, where the countersunk holes are. They should bite into the printed plastic on the opposite side
- One at a time, remove the corresponding screws from the extruder, feed them through the countersunk holes in the bracket, and re-attach.
- You will have to pull the wiring connector from inside the left vertical beam on the gantry. There is a removable black strip that covers the channel, just pull that out, remove the cable, and put it back.
You may have to shave away some plastic on the inside of the extruder screw holes. It is a tight tolerance to connect the screw back into the extruder head. The original model recommends an M3x6 screw, which does work with this remix as well.