1 / 2
Tradrack Feeder Brake Rework - 5.5mm Ball Bearing & More — zdjęcie 1
1 / 2

Tradrack Feeder Brake Rework - 5.5mm Ball Bearing & More

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tradrack Feed brake w/ filament sensor, modded to fit 5.5mm ball bearings, cleaner appearance, and tighter tolerances

Ocena
5 / 5
Polubienia
9
Pobrania
67
Wydruki
0
Wyświetlenia
262
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0

Edit 11/24/2025 ----------------------------------------------

After a long hiatus, I modified the ECAS interface for more reliable feeding and unloading for endless spool function. To install ECAS, make sure you have removed both the rubber base and black plastic ring from the bottom (like WW-BMG for A4T) I also removed 0.2mm from the Feeder Hinge to account for slicer layer height rounding and over extrusion. This ensures there is not rubbing between lanes so the hinge can still move when lanes are aligned tightly. Also added zip tie channel for cable management, still experiencing some reliability issues, so I think I might just do a full redesign. Coming soon…

-------------------------------------------------------------------

 

Edit 03/03/2025 ----------------------------------------------

Modified the lane height again to align the lane exit to more closely match the entrance on the selector.

-------------------------------------------------------------------

 

Edit 02/25/2025 ----------------------------------------------

Modified the lane, shifting it up 0.25mm for better compression when the servo goes down. Also modified the magnet height to make it more flush and secure

-------------------------------------------------------------------

 

I came across this amazing Tradrack mod by Leon Jongsma (built from foundations from RefractingPrism) I really liked the idea of having a filament sensor in the gate, but I didn't have any 7mm bearings. I had many extra 5.5mm bearings (from having a toolhead filament sensor on my XOL toolhead) and figured I modify this lane to use those. 

I also found the magnetic force was a little weaker than I was hoping for, so I lengthened the hole on the lane to allow for either a longer magnet (I had a 6x6mm magnet) or doubling up on the original size. I have included both this version and the more standard 3x6mm version.

While I had it open, I also took the opportunity to slightly widen the switch mounting holes, tighten the tolerances on the ECAS fitting, and smoothen some of the geometry out. The updated holes for the filament sensor switches all them to be secured with m2x8 screws. My ECAS fittings had a tendency to fall out on the original one, so making the hole smaller helped. Also, the small gap at the bottom of the gate was bothering me, so I smoothed it out.

I noticed that the brake piece didn't fully rotate to the upper endstop on the lane, so I might be making some more modifications. I'm also working on a reworked end piece to prevent the brake from falling out of the last lane among a couple other Tradrack Mods coming soon (hopefully) I will link to the files as I release them.

 

Again credit to Leon Jongsma and RefractingPrism for coming up with the original designs. I just tweaked things a bit to suit my configuration