PTFE Tubing Mod Creality Sprite + Runout Sensor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
PTFE tubing to keep filament from pulling up on extruder
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 168
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Filament kept pulling up on my extruder at the far sides of my x axis and causing poor layer / plate adhesion. This fixes this problem for any Creality sprite extruder. Filament runout sensor optional. Uses M6 pneumatic fitting for the extruder mount and the side that goes into my dry box from Comgrow. M10 fittings to the filament runout sensor. I found it best to cut my filament to a point (45 degree cut) to make it feed through the tubing best. This is honestly all way overbuilt, especially on the runout sensor fittings but it works super well for me. The extruder mount is printed with the side that you see facing the back of the extruder on the build plate. The runout sensors are printed with the flat side, that the fitting screws into, on the build plate. I've attached links below to the filament dry box that I used and the PTFE / m6 + m10 pneumatic fittings. Let me know how it works for you and if you'd like to see any adjustments!
Drybox: https://a.co/d/9ItetkM
PTFE Tubing: https://a.co/d/35HuKIa