1 / 9
Ringwraith Guitarist (32mm/54mm) (DND / TTRPG) — zdjęcie 1
1 / 9

Ringwraith Guitarist (32mm/54mm) (DND / TTRPG)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Ringwraith Guitarist for DND and other TTRPG (or just a decoration I'm not the 3d printing police)

Ocena
0 / 5
Polubienia
6
Pobrania
21
Wydruki
0
Wyświetlenia
104
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Similar to the trio of demon guitarists this was originally intended to be a prompt for a monstrous looking guitar that turned into an actual monster (source image and some prompting included in the title of that image). A similar scenario could be used for this creature to the one that I wrote there or it could be a mini-quest for a Bard character in order to overcome death itself (perhaps a bonus death savings throw, saving another player etc... etc...)

The output from the AI ended up having a pretty rough bow or warp in the guitar neck. I tried to correct this and thought it looked good, printed a 32mm model and found it was still pretty bad so I went back and setup Armatures to pull the left arm back then did more sculpting to pull it around. It's still not perfect but looks much better. Beyond that I did the typical cleanup on fingers, tracing some of the details (shoulder, elbow, chest armor) and thickening things up. I've printed three of these now so I'm done tinkering for a bit but if I do more I'd remove the small gap between the guitar and belly as support cleanup from in there is a bit of a pain.

As usual for FDM I would print this on its back. You can put it on a baseplate but I like them rising up, shaking the ground like a really epic baseline.

If people want the bent version or if there is interest in the originals/blend files I can upload these too but the straightened version seems like the best for now.

Category: Other

Tagi