1 / 3
VW TRANSPORTER - SPARE WHEEL MOUNTING SPACER SLEEVE  701801913 — zdjęcie 1
1 / 3

VW TRANSPORTER - SPARE WHEEL MOUNTING SPACER SLEEVE 701801913

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replaces spacer sleeve VW Transporter T5, T6 spare tyre carrier. Height can be adjusted to suit different tyre sizes.

Ocena
0 / 5
Polubienia
7
Pobrania
34
Wydruki
0
Wyświetlenia
1425
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The spare tyre carriers on VW Transporters have spacer sleeves  on their support bolts which are apparently intended to prevent over tightening of the carrier.   Unfortunately despite being designed to be held on captive “barbed” bolts, they are often lost in use. 

These simple replacements are partly cosmetic, and partly functional - they serve as a visual aid when the bolt is “tight enough”, and protect the thread somewhat from road grime.

They are a tight fit over the bolt, but can be fitted by screwing them on by hand.  This is to prevent them falling off (see first paragraph), but in the event of a loss they are simple enough to replace!

I've printed these in PETG 0.2mm QUALITY mode on PrusaSlicer with three perimeters and 25% infill, and they have stood up well to 10,000 kilometres of harsh driving on some of Australia's “more challenging” roads.

Before printing - check that your spare tyre is secure and measure the height of each spacer (depending on the tyre size you have, this may vary).

Open the STL in your slicer and unlock the coordinates box as shown below.

Adjust the “Z” dimension ONLY to suit your specific requirement.

 

Tagi