Triton Doweler Vacuum Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The triton doweler vac intake is too short and my vac kept on falling, fixed :)
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 51
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
The Triton dowel machine is a machine I find super nice. They seem to have fixed most complaint I have seen on YouTube (and I am not bothered by the absence of mark pointed out in the 10min workshop). However I had to issue: the inability to center on 15mm board (fixed with the fence attachment) and the vacuum intake being to short and my vac never holding.
I made an adapter with a 4 ways outer snapfit + 4 snaptfit that hod onto the two grid bars in the vac intake. It snap strongly and needs to press firmly on the four snapfit to remove. The only issue I see so far is the strength of the inner snapfit.
This needs to be printed in PET or Nylon to have enough flex, PLA will snap. It needs support, prefer tree support on the build plate.
There is an input_d parameter in the SCAD file that could be modified to adapt to other vac (mine is at 31.7mm).