Sound Blaster Recon3D shroud
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a model for a one-piece squared shroud and backplate for Creative Sound Blaster Recon 3D -series sound cards.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 51
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is a model for a one-piece squared shroud and backplate for Creative Sound Blaster Recon 3D -series sound cards.
It's relative straight-forward piece; Remove original shroud if present, slip your card in through the opening, and put screws back in place. Note that there's nothing really holding the screws in place beyond tension though you can probably slip in nuts for the IO-side screws but it shouldn't be necessary. However if you have a model with LEDs, you'll have to either remove them or bend them down.
I recommend printing it upright with the IO-shield side up. On the connector side there are support pegs that are to be removed before use and they will prevent installation. No need to clean up remains after cutting them, this side will be hidden when installed. No further supports required. Note that PLA has a low softening temperature so if your case and components get hot around the sound card, do not use PLA.