1 / 9
Spooler filament Artillery SW X4 Plus - v2.0 and V3.0
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A better way to spool the filament on this printer, Second and third version. It works perfectly for me - smoother
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 21
- Wydruki
- 2
- Wyświetlenia
- 417
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A spooler improvement aiming to limits the friction with the original spooler. The original one it gives me some problems with the flexible filaments (big tension).
Parts not printed (bought on Amz):
- steel bar diam 4,9, length 104mm
- U bearings 5x16x8
- Screws M3x15
- Nuts M3x5 for soldering in 3d prints
Improvements in version 2.0:
- the cylinder spool is remade, with less diameter, aiming to gain in diameter when changing rolls (the bearings have also more space to roll with no friction)
- one side fixed on the cylinder, so you nedd to print only one bracket, so you need just one screw.
- longer cylinder
- bearings have more place for different sizes of filament rolls
Improvements in version 3.0:
- no need for the collar anymore, the bar support is attached to the roller (and for this, the left and the right side rollers must be printed individually, they are not symetrical)
- no need for soldering nuts, neither bolts.
- a new brand roller to install the filament onto it.
When I tried to install on the left side, I observed a slight decline of the bearings bar, due to the fixation system inside the spooler arm. Both are needed to be print (they are identified with R/L letter)