U.S.S. Benchy Enterprise - NCC 1701
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Benchy meets the U.S.S. Enterprise and becomes a StarShip ⛵🚀✨
- Ocena
- 5 / 5
- Polubienia
- 53
- Pobrania
- 103
- Wydruki
- 1
- Wyświetlenia
- 1365
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The printing does not present any particular issues. You can print in PLA or other materials.
As you can see from the images and the project, the 'UPPER' and 'DOWN' components require a brim. The 'DOWN' component also needs supports.
Be careful with the interface layers, which must be turned off. This is the best printing method I have found to achieve good quality.
From the images, you can also see how the different components should be assembled. A small amount of glue is required. The holes and pins will help you align the parts. They have a very tight tolerance, so you may need to clean the pins or holes properly.
The holes in the 'MIDDLE' and 'REAR' components are sized for a small piece of PLA filament.
The stand is necessary because Benchy is too heavy at the front. You could adjust the printing parameters to balance it and add weight to the back
N.B.
I have added version 2 of two files because I had forgotten the pin for aligning the two pieces