DeLorean DMC-12 People Barrier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A seat belt to door post clip to provide a visual barrier to keep people out of the car during car shows.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 213
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
“Hey… What the hell do you think you're doing?”
“Dude! I LOVE YOUR CAR! I've never sat in a DeLorean before!”
“Get out of my car! You don't climb into someone's car at a car show without their permission!”
“Oh, no man, I just wanted to take a peek at your time circuits and look at the flux capa-”
“GET. THE. F***. OUT. OF. MY. CAR!”
Yeah, this is a thing that happens at car shows.
The doors go up, the assholes sit down.
A lot of people don't respect other people's things, and a car as iconic as the DeLorean just draws people in to look. Most people will admire and move on… Some will not think twice about shoving their head inside and possibly going further. I don't begrudge them the head shoving, but sometimes the head shoving results in shoving their heads up their as….. cough
Sorry… [/rant]
These little doohickeys will clip to the front strike pin on the A pillar and hold the seat belt buckle in place, stretching the belt across the door opening.
Two versions are included: One with magnet pockets and covers, and the other without.
The CAD files are included to allow for adjustments to the magnet pockets for the magnetic version.
Hardware needed:
Optional: 8x M3x18, 20, or 22mm socket head cap screws (recommend 20 or 22) to provide reinforcement through the layers at the strike pin and buckle retainer points. Not strictly necessary, but adds a ton of strength. Likely to bend the door strike pin before you break the print.
Magnets for the magnetic version. ½" by 1/8" neodymium disc magnets.
Press/glue these into the caps, glue the caps into the body of the main print.
Modify this at your whim, though I recommend using at least 10mm disc magnets. Neodymium is highly recommended.
Print Settings:
Material: ABS or ASA (for storage in vehicle in the summer)
Walls: 6+ added strength. I printed 12. More walls, less likely to need screws for longevity
Infill: 35+. More walls, less infill required.
Both passenger/driver side units with magnets and covers prints in about 3.5 hours on a Bambu X1C with the default .2mm quality profile and the single filament color swap.