1 / 1
Low Profile K1 / K1C Top Spool Holder for Unibody — zdjęcie 1

Low Profile K1 / K1C Top Spool Holder for Unibody

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a top spool holder to sit on top of the Unibody Riser on a K1 / K1C. It was meant to be low profile.

Ocena
0 / 5
Polubienia
4
Pobrania
62
Wydruki
0
Wyświetlenia
404
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This holder sits on top of https://www.printables.com/model/891616-creality-k1-k1c-unibody-riser-frame

 

This is meant to be low profile, as my printer sits under my desk, so although not optimal, it prints TPU just fine!

 

The tolerances should be fine on almost any printer, i printed on a K2. I printed the side on the large flat bottom with no supports in PLA. I used .12 layer height, though adaptive would be better, and 5 walls, 25% infill. This is probably overkill though. 

 

The arm has an m4 hole in it for a PC6-M4 adapter to go in, though i ended up not even running one.