1 / 3
Creality K2 Plus bowden tube clip
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a narrower bowden tube clip to hold the PTFE tube on top of the cable chain so that it doesn't touch the…
- Ocena
- 4,5 / 5
- Polubienia
- 110
- Pobrania
- 980
- Wydruki
- 1
- Wyświetlenia
- 3898
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 3)Remiksy (1)Kolekcje (211)Powiązane
This is a narrower bowden tube clip to hold the PTFE tube on top of the cable chain so that it doesn't touch the glass. The original factory K2 Plus clips tend to release and slip off the chain after a while, and misplacing them limits the bending capabilities of the chain.
The design takes into consideration the following:
- there are two STLs, one has a tighter hole, which holds the tube in place in order to prevent it from slipping back and forth during movement, this ensures proper distance being constant from the top glass. The other one has a bit larger hole, this allows free movement of the tube as required during movement.
- the holes are side located, with two such clips you put the one with the tighter hole closer to the hot end, oriented to the outside of the chain, the other one with the larger hole is orinented towards the inside of the chain (see attached photo).
- the clips are narrower than the originals, which ensures that the chain bending at the cell where the clip is located is not blocked in any way (wider clips can block bending of the chain in that cell if they slide towards the middle).
I printed in PETG. Designed in FreeCAD.