1 / 1

Ikea-Fan-Filter-Unit

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Printed parts for a Fan-Filter-Unit i use for mycology. It uses a 45L Ikea Samla and an Ikea Starkvind Filter.

Aktualizacja u źródła: 27 lut 2025

Informacje o modelu

print the adapter
slot the long part together
lay the long parts on the long side of a 45l Samla box from Ikea
- pay attention to the angle - the part wall should follow the box wall exactly
- the recess should point upwards
place the short parts in the recess
- wall angles should also meet nicely
drill all holes through the parts and box bottom
- press gentle against the box walls while drilling
screw the parts with metric m6 bolts - i just had them on hand - to the bottom
cut out the bottom aligned to the parts - or may be better with 2-3mm or 1/8" overhead
place the filter with the felt sealant pointing to the box opening in the resulting frame
- should fit snugly and tight

print the inlet-drill-template
- it is just a template, reduce features in your slicer as far as possible
- it is required to get the fit of the fan holder right
place the template in the slots on the side of the box and align on top
drill a hole in the box
repeat on the other side if you plan to use two fans like i do
use a 121mm hole saw in reverse to create the main fan holes

print the fan parts
- they are included as a Prusaslicer project as they use a stamp-modifier to print without top and bottom, and defined infill for the prefilter case
put prefilter fleece in the frame and clip the lid in place
screw fan holder, pre filter and 120mm fan together
remove or loosen the screw beneath the fan hole
put the thick lip of the fan holder on the opening and gently press the other side of the hole on the small lip
reattach the screw

print and use some samla clips to keep the lid closed
- I use https://www.printables.com/model/131601-never-lost-ikea-samla-clip-45l-65l-v2/remixes
print the feet
- included as a Prusaslicer project as i adjusted the infill density on top
clip on the feet
adjust your fan speed according to ( not my content! )