Vertical Single Dose Coffee Bean Storage

Intro

I wanted a holder/organizer for my single dose coffee bean storage that doesn't take up too much horizontal space and is to see the content of the tube (empty vs. full), but I couldn't find any to liking. So I decided to create my own version while I'm teaching myself how to use FreeCad. These storage options are meant to be attached to wall or other objects with flat surface with the use of double-sided tape or Command strips.

There are two versions: Clip vs Insert.

Clip (full and minimal)

There are two versions of clip: Full and Minimal. Both do the same, except Minimal version uses less material by removing the backplate. The backplate is supposed to give more sturdy control of pushing in and pulling of the single dose tubes. The Full version works better, but I wanted an option to conserve our precious plastic.

Insert

This simply requires the tube to be inserted sides ways. It uses less plastic than the full version of clip, but slightly more than minimal version of clip. The insert type has a tight fitting. 

Which one do I like?

Aesthetically, I like Insert version better. Functionally, it depends. The Clip version saves more space as you do not need any spacing on the side to allow room to insert the tubes.

Printer Settings

- Support: Yes (only for Clip version)

- Infill: 10% (I'm sure less infill is permissible)

- Material: PLA (other rigid material should be fine)

- Orientation: Print them on the side (default orientation) to ensure maximum strength around the insert/clip parts

- Scale (for Clip version): 100% for tight fit // 101% for loose fit (still be slightly snug)

Installation

Use Command Strips or double-sided tape to secure to a wall or flat surface.

Notes

You can get the vials I used here: https://www.amazon.com/dp/B0759TB72J?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_3

That's all for now. After prolonged use, I might add or update things.

Enjoy!