1 / 10

DO NOT PRINT - FIXES IN PROGRESS - Reusable Dust Bag Fits Eufy L50/L60 SES and Various Other Models

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A reusable dust bag that can simply be emptied by removing the bag and sliding the panel to one side to empty.

Aktualizacja u źródła: 22 paź 2025

Informacje o modelu

DO NOT PRINT - FIXES IN PROGRESS

Slight design change from photos and instructions, new design the front face and slider panel twist together

No additional hardware necessary

Fits Models

Eufy L50 SES and L60 SES

Congo 10000, 8090 Ultra and 9090 AI

Note: Print the bag in TPU with the opening facing upwards as there is no supports required to print!

Printing Filament Materials ------------------------------------------------------------

Front and Slider Panel - Ideally PETG but PLA/ others will work!

Gasket and Dust Bag - TPU (Gasket can be whatever proper gasket material) Foam tape should work good too

Instructions ------------------------------------------------------------

Simply remove the reusable dust bag bag when It is full and slide the cover to one side to empty into the trash! (Shown in step 4)

If you want to make your own gasket rather than printing in TPU the dimensions are

Inner diameter = 30 mm Outer diameter = 40 mm and 2mm thick

Step 1. Glue gasket onto front panel. The gasket fits into the cutout. (Either TPU or any other gasket material cut to shape)

Step 2. Thread the front panel into the slider panel.

Note: They will not thread together flush, there will be a gap and that is on purpose.

UPDATE

The two panels will twist together now with a slot.

Step 3. Proper front panel and slider panel assembly.

Step 4. Once the front and slider panels are assembled. The assembled part slides into the groves in the open side of the dust bag.

Simply remove the reusable dust bag when It is full and slide the cover to one side to empty into the trash!