JP Performance PACE museum like Car Display Stand (1/18 scale) *updated version*
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I updated my display stand design for 1/18 scale cars, for easier glueing
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 379
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A car display stand like in the JP Pace museum (https://jp-pace.de/pace.html), mainly created for the 1/18 scale cars from JP Kraemo (https://jp-kraemo.de), also fits the 1/18 scale Boost Wars, but it's close. As the cars are Minichamps 1/18 scale cars it should also fit other models.
For lightning I used a 12v addressable RGB strip and a WLED ESP32 controller, I designed the base so you have an in- and output, so the bases can be connected in series and only one WLED controller need to be used. I used standard 4 pin RGB exentsion connector, e.g. used in PC's to connect to the mainboard. A JST style connector would be better, but I would had to buy some specially for that.
For the top I bought a satin 3mm plexiglass plate, which is 28 cm x 12,50 cm with a corner radius of 1,3 cm, which just slights loose on top, I bought it in germany at https://www.plattenzuschnitt24.de/PLEXIGLAS-GS-satiniert-weiss-3mm.html.
Last but not least I added white paper to the bottom on the inside, as a reflective layer.