RatRig V-Core 3.1 400mm Rear Shelf Cover One Piece
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Turns the printed rear shelf in the VC3.1 400mm into a single piece that can be laser cut out of ACM or Polycarbonate
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 200
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
DXF file to get a single piece cut out to serve as the rear shelf cover in the VC3.1 400mm. Single piece design is stronger and seals substantially better than the stock printed type most V-Cores came with. Includes a nice TPU gasket to help it seal better and protect the umbilical wires from rubbing on the shelf.
BOM:
- 1x ACM/ACP or Polycarbonate 3mm Thick Shelf
- 4x M6x12mm SHCS
- 4x M6 3030 T nut/hammer nut
- 4x M3x8mm SHCS
- 4x M3 (4MM OD) Heatset insert
- 4x Rear Shelf Support pieces (printed ABS or better)
Print the shelf support pieces and install the M3 heatset inserts into them. Bolt them loosely over the rear electronics panel. Slide ACM shelf into place and bolt with the M3 bolts to the shelf supports, and then use the M6 bolts and T nuts in the rear of the shelf to secure it to the extrusion.
TPU Umbilical Gasket - you may need to adjust this depending on how big your umbilical is and/or what other wires you have running through this cutout. STEP file included.