Refrigerator drip tray replacement for WP2206670B (Maytag, KitchenAid, Whirlpool)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement/custom drip tray for WP2206670B, uses single deep collector instead of hard to clean ridges
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 194
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
Inspired by https://www.thingiverse.com/thing:4682298
OEM Part: https://www.whirlpoolparts.com/PartDetail/Dispenser-Tray/WP2206670B/826974
Our refrigerator's drip tray was starting to show its age, and had calcium deposits that were difficult to clean off (especially between its ridges). I looked at the design by https://www.thingiverse.com/rapalax to see if it would work for our needs, but it appears to also have the ridges, so I opted to create my own design.
I am new to 3D printing, and decided to learn CAD (using OnShape currently) to create my own variant.
NOTE: The front face is 255 mm wide and the rear of the top plate is 223 mm, so if your build volume is lower on the X/Y axes, you may need to rotate it 45° in order for it to fit. This worked for my Ender 3 V2 Neo with an X/Y print area of 220 mm x 220 mm. I opted to not flip it vertically when printing so that any support remnants would remain on the underside.
Also, I didn't print it high quality for the pictured prototype, as it's not a detailed display piece and my priority was more on rapid printing than beauty.