Sonoff ZBMINI and MINIR2 - custom case - switch case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a custom case for the Sonoff ZBMINI and the MINIR2.https://sonoff.tech/product/diy-smart-…
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 620
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This is a custom case for the Sonoff ZBMINI and the MINIR2. https://sonoff.tech/product/diy-smart-switches/zbmini/ https://sonoff.tech/product/diy-smart-switches/minir2/
The aim is to make it possible to use the relay connected in an aesthetic box, directly on the wire of a lamp as in the video.
For a good result, it is preferable to print the case with a 0.2mm nozzle, but the result is still satisfactory with a 0.4mm nozzle. This switch pin is made with extra lenght, if you whant a flush switch, you can trim it.
To close the case, you can use two 16mm M2 screws.
List of files by cable sizes:
- round 6.8mm diameter
- Light_switch - Top_case - h6.8mm - l6.8mm.stl
- Light_switch - Bottom_case - h6.8mm - l6.8mm.stl
- roud/flat 5.5X6.9mm
- Light_switch - Top_case - h5.5mm - l6.9mm.stl
- Light_switch - Bottom_case - h5.5mm - l6.9mm.stl
- flat 3.15X5.1mm
- Light_switch - Top_case - h3.15mm - l5.1mm.stl
- Light_switch - Bottom_case - h3.15mm - l5.1mm.stl
If you want a specific cable size, leave me a comment ;)
Next steps:
- DONE - Modify the case so that the screws pass through the back of the case (assuming that the face is on the button side).
- Make variants of this project for more Sonoff modules:
- ZBMINIR2
- MINIR4M & MINIR4
- ZBMINI - L2
- S-MATE2
Category: DIY