1 / 22
Vanquish VS4-10 - Chassis Parts / Rear-Flat-Shock-Tower / Body-Mounts / Battery-Tray / Etc — zdjęcie 1
1 / 22

Vanquish VS4-10 - Chassis Parts / Rear-Flat-Shock-Tower / Body-Mounts / Battery-Tray / Etc

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Vanquish is slowly gaining a foothold in the European market. Here are a few parts for the world's most stable chassis.

Ocena
0 / 5
Polubienia
22
Pobrania
248
Wydruki
0
Wyświetlenia
944
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution

Part Description: Rear flat Shock-Towers for Scaler withs Flatbeds like RC4WD K10 or Mojave II

  • No holes on the loading area for the shock absorbers. No cantilevers.
  • Pinted in PLA with 15% infill, if you like it more stable use PETG or ASA.
  • Requires 6 pieces of M3x12 to attach them to the chassis.
  • Shock absorbers require spacer (you can see it on the photos).
  • Works with 90mm shocks, 80mm would be even better.

Part Description: Front Battery Tray

  • Instead of the second servo, this holder is mounted to insert a shorty lipo.
  • Not suitable for VFD gearboxes. Gear guard is in contact with the bracket. New version in progress.
  • Printed with PLA and 15% infill.
  • Requires 4 pieces M3x8 screws.
  • Works great with RC4WD Blazer and K10.

Part Description: RC4WD Chevrolet K10 Body Mount - Adjustable Offset

  • Adapter to mount the RC4WD K10 body on a VS4-10.
  • There are two versions, a simple one and one with an integrated rock slider that also has adjustable offset.
  • Both versions require M3 screws.
  • Printed with PLA and 15% infill.
  • To print the other side, simply mirror it in the slicer.

Part Description: Team Raffee Co. Land Rover SUV Gen 1 (3-Door) Body Mount

  • With these parts you can mount Team Raffee's Rangerover Classic on a VS4-10 chassis.
  • Bodymounts (left and right to the electronicplate): Drill 3mm holes into the recesses of the body shown in the picture. Body can be connected to the holders with 18mm M3 screws.
  • Frontsupport: Drill 2.5mm holes in the body and connect the front support to the body with 6mm M3 screws.
  • Rearsupport: Use glue or drill 2.5mm holes in the body and connect the rear support to the body with 6mm M3 screws. Universal bumper mounts are required, alternatively printed tubes or aluminum tubes are also possible.