BenchyFormers - Articulated Benchy

After 1 week finaly finished, the BenchyFormers. An articulated Remix of Benchy inspired in Transformers movies. 

This remix was maked exclusively for Benchy Contest. when I saw this oportunity I started to think at some unique think could make to this contest. 

I made the minimal possible modifications to the original model for the transformation.

And yes, I didn’t scale up the model, I adjusted all the modifications using the original Benchy dimensions.

Model Parts Names

Assembly

Attention
Check the image below to assemble the Head on the Neck correctly. Otherwise you will break the joints.

The leg and foot are printed in place. You can remove lint and fix any print issues with a paper knife (shown below) to move the foot easily without breaking it.

I make these simple animations to make it easier to understand.

I really enjoyed doing this Transformation, I'm thinking about continuing to develop the model further and even making a bigger one, what do you think?

Recommendations:

Material: Tested with PLA, but recommended materials are PETG, ABS or ASA.

Print Configuration:
Layer Height: 0.18 mm
Use the Support only for the Base and Ams.
Use the Brim only for the Head and Wings: Brim larger than 8 mm for good bed adhesion.
Print Sequence: By Object

Note: Pay attention on the overhang areas, make sure that your printer is calibrated, otherwise you will some printing problems.
If you have any problems printing the Head, instead of "Head.stl" use "Head with stabilizers.stl", this will solve the problem. After printing, you can remove the stabilizers.