BMW M60 Belt Tensioner Dampener Bushings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement bushings for the M60 engine belt tensioner dampener bushings.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 170
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
After 30 years and nearly 300,000 miles the dampener bushings on the belt tensioner on my 530iT were hard as a rock, crumbling and loose. The OEM replacement is now $250!
Print these in TPU, I used Overture High Speed TPU on my Bambu A1 Mini.
To use these bushings you have to push the old ones out, it was easy to remove mine due to their condition. To remove the hardened rubber that was adhered to the inner aluminum sleeve I carefully used channel lock pliers to shatter it around the perimeter. Eye protection or safety squints required!
Next print four of the bushing halves and insert the inner sleeves into one half, and insert those in to the dampener. Finally, insert the other halves. Should be able push the printed bushings in with your thumbs but it should take some force.
Here is a link to the Real OEM parts explosion and part numbers: https://www.realoem.com/bmw/enUS/showparts?id=HK23-USA-05-1993-E34-BMW-530i&diagId=11_4838#11281736857
This parts explosion shows the e39 and e39 belt dampener but the part numbers are correct. The e39 dampener for the M62 might fit M60 engines. I believe that it's hydraulic whereas the M60 dampeners are just springs encapsulated in rubber to protect them from rust. I plan on spraying Plastidip on mine as the rubber is failing in some spots and may allow water inside.
Note: While disassembling the tensioner assembly to replace the pulleys be careful not to damage the thread on the long bolt that goes through the 80mm upper pulley. I destroyed mine with a pair of vice grips trying to remove it as it was seized inside its sleeve so bad that it sheared the threads off completely. Use some sort of penetrant first to try and free it up. The bolt is non standard with a wider shoulder than the thread diameter and you will need to order it online. Part number: 07119900236