Parametric Tripod Mount for a Flashlight -- Inverted Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A variation of the Parametric Tripod Mount for a Flashlight where the threaded insert is inserted from the top.
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 27
- Wydruki
- 1
- Wyświetlenia
- 465
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
I got some feedback on my Parametric Tripod Mod for a Flashlight pointing out that the head of the threaded insert doesn't have any ¼"-20 threading where the allen wrench fits in. As a result, some tripod mounts may not thread into the insert properly.
I solved this by inverting the ¼"-20 threaded insert. In this model, it inserts from the top of the model and screws down to sit flush with the bottom of the model. The ¼"-20 threading goes all way to the bottom of the insert, which means it engages the tripod's threads much sooner.
After printing, I used a ¼"-20 threaded insert to mount atop one of my tripods. At most angles, my small focusable LED flashlight fits well and a rubber band holds it snugly upside down.
The base of flashlight I'm using measures about 70mm long with a diameter of 27mm. The included STL file (Flashlight Tripod Mount -- Inverted Insert -- 27mm x 70mm.stl) was generated using these values.
If your flashlight isn't that size, install a copy of OpenSCAD and make changes to these two variables to match your flashlight:
- flashlight_height: The measurement (in mm) from the base of the bulb to the end of the flashlight.
- flashlight_diameter: The measurement (in mm) of the flashlight handle's diameter.