Square Sunix Filament Dehydrator Upgrade

This is an extension piece for the square shaped Sunix Food dehydrator.

This print is in eight pieces, designed to be printed on a Prusa Mini:

• two small corners
• two large corners
• two small spacers
• two large spacers

Notes

I'm sure print could be re-mixed to be printed with fewer pieces. I designed this quickly using corner pieces designed to be too small so I could print the expansion pieces without re-printing the corner pieces.

Printing Directions

I recommend printing this in PETG since this will be subjected to heat. I printed the corner pieces with brims, since they are thin and tall. Removing the brim was a pain- I used a key to clean out the channel.

Assembly

1. Print the pieces.
2. Remove the trays that came with the dehydrator.
3. Put the small corner pieces in opposite corners.
4. Put the large corners pieces in the remaining corners.
5. Slide the large spacers into the large gaps.
6. Slide the small spacers into the small gaps.
7. Place half of an old spool holder in the bottom to lift filament away from the heat vent at bottom. (This is most likely optional - but I do it to be cautious.)

Usage

1. Install the walls.
2. Place spool to dehydrate inside.
3. Place the lid on top.
4. Turn on and select temperature and wait. I use: 
   • 50°C for PLA for 4 hours
   • 65°C for PETG for 4 hours