Qidi Plus-4 Glass Top Vented Corner Risers (short gap)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A set of corner risers to lift the glass top of the Qidi Plus-4 about a half inch (12 mm) to allow venting
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 120
- Wydruki
- 2
- Wyświetlenia
- 610
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I finally upgraded to this Qidi Plus 4 printer. The glass top is great, but for low temp prints (PLA, etc), where do you put it? ALSO, my printer is in my garage which gets dusty. So I want the top in place just to reduce dust settling inside the printer.
A riser for the glass top is not new - but other models I've seen are either way too big or way too small. So I made this set of risers for myself.
The total vent area is NOT equivalent to removing the top completely - I have no measurements of how effective the venting is … so you have to evaluate if these are effective.
My goal was something quick to print, stable, and low profile to avoid clash with the functionality of the rest of the printer. I figured the point is to vent, so there is no need to “fully” fill the gaps, like over the handles.
As shown in the photos, these were printed using Elegoo PETG. Each corner piece took about 1.1 hours using 0.24mm Draft setting in QIDIStudio.
You need to print:
- qty 1 Spool Corner
- qty 1 USB Corner
- qty 2 standard corners