Scarlett Solo (Gen 3) Desk Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A desk stand for the Focusrite Scarlett Solo 3th generation.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A stand to slightly elevate the Focusrite Solo 3rd Gen from the deck, so the cable can be neatly routed underneath the interface. The gap at the rear is over 10mm tall, and can easily accept XLR cable.
In this print setting, I try to use the least material as possible, while being confident at its part strength.
Tested Print Setting
2 Parameters
5% Gyroid Infill
I only printed one without helper disks, and I noticed one of my thinner wall did slightly lifted from the bed, and a small one layer z-shift defect occurred. So I added them to help with bed adhesion. Feel free to turn off the helper disks, if you're confident in your bed adhesion.) If you don't want to use helper disks, brim is recommended.
NO support; I have added chamfers from the original model so it can be printed upright with no support.