Wyze CornerOne
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Taking advantage of the metal frame with (3) STRONG N52 6mm X 3mm magnets was able to get a Wyze Cam v3/V4 mounted in the back left corner of the CoreONE and clear all movement of the gantry. It can also be mounted in the front left corner however you will not be able to utilize the full print area as there can be a collision with the gantry.
Tested in PLA and PETG and works without fail. Routing the wiring can be tricky. I removed a pin and ran the wire out of the back of the plexiglass top back left corner above the camera. This is not a permanent mounting location for the wiring.
**** Cable Routing ****
Use the BuddyCam instructions you can route the power cable through the same opening instead of through the top.
Magnet Resources:
totalElement
Magnet For Less