Nordic Ski Waxing Profile and Mounting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lightweight and compact ski waxing profile. Good for small work shops or traveling.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 293
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter Sports
- Licencja
- Creative Commons — Attribution
This is a working revision of some Nordic/XC ski waxing profiles. They are for the most part simple to make, and have multiple options for bench mounting and could pack/travel well if needed. Ive used it a few times and its acceptable but there are a few things I think I would eventually update for a nicer experience so look for upgraded revisions eventually.
I printed the blocks and the binding mounting out of PETG with 15% infill. I dont think I would cut down on the infill more than this. There are TPU mounting block I made from 95A material with 15% adaptive cubic infill. The system can work with or without the TPU blocks but I have found if you dont you the TPU blocks, then the profile blocks will need something to raise them up to lock into the binding lock appropriate. The binding lock uses a custom M24x2.0 thread pitch so each half turn will raise or lower the lock by a mm.
Provisions for mounting to a table with an M5/M8s hex bolts or tee bolts can be used. I used quick clamps as I have found its faster and I like to have my workspace easily cleaned for other projects. The binding pin should be able to use 4mm or 1/8 round bar. In my testing I used a 5/16" transfer punch since I didnt have barstock yet and it worked well.