1 / 2
Garage Door Adapter for 2nd Gen. Ring Alarm Contact Sensor — zdjęcie 1
1 / 2

Garage Door Adapter for 2nd Gen. Ring Alarm Contact Sensor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a simple tilt adapter-hinge to be used with Ring Contact sensor to track garage door opening/closing

Ocena
5 / 5
Polubienia
67
Pobrania
675
Wydruki
7
Wyświetlenia
3778
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Simple and quick print. Prints in-place, no need for any supports. Print it with 4 perimeters and 100% infill, to be a bit stronger/heavier. After printing make sure to work it out a bit manually so it moves freely. 

Mounting instructions

Put the RING contact sensor (bigger part) with the included self-adhesive to the longer flip of the hinge, on the very edge. (see included pictures).

Use a piece of double adhesive tape or similar material for the shorter hinge flip on the back, to attach it to the garage door. Magnet from the contact sensor goes just bellow (attach it with the included self-adhesive directly to the garage door), leave something like 2-3mm in between them, since there is some minor magnetic attraction. 

References

This design is based on the Parametric Hinge scad. The parameters are fine tuned to fit the Ring Alarm Contact Sensor and a needed swing, and one of the flaps was cut to make it smaller.

Tagi