Sensecap T1000-E Magnetic Charging Sled – Secure, Dual-Orientation Dock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic charging sled for Sensecap T1000-E with secure slide-in design, dual orientation, and easy cable management.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 146
- Wydruki
- 1
- Wyświetlenia
- 917
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
This 3D print helps position the magnetic charger for solid contact and worry-free charging of the Sensecap T1000-E in any orientation.
Most charging sleds I found rely on the built-in magnets to keep the device seated, which didn’t inspire confidence for my upside-down use case. I liked the sliding and locking component of Ducktator’s design for the A/B model, but since it wasn’t compatible with the E model, I decided to create my own.
While designing, I added a second connector position and looped the cable guides together. This allows you to slide the device in with the lanyard mount facing up or down. The looped guides also simplify cable routing, making setup easier regardless of orientation.
A small notch provides easy device removal and leaves space for lanyards if needed.
I’m uploading four variations to suit different needs in terms of filament use, print time, and aesthetics:
- V1 – The base model, a solid starting point.
- V1a – Adds holes for mounting with flathead #8 screws.
- V1b – Features an open aesthetic and a flat surface for mounting with double-sided tape or other adhesives.
- V1c – My original prototype with a fully open design that I personally like.
I printed mine on an Artillery X1 with no supports. Aside from minor stringing and cleanup around the connector hole, it performed better than I expected!