1 / 1
Ubiquiti UNIFI USG & switch with ASUS ac68u rack
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My USG cannot load full speed if I use PPPOE, but good speed if use IPv6 (DHCP from ISP).
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 95
- Wydruki
- 0
- Wyświetlenia
- 2032
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (26)Powiązane
My USG cannot load full speed if I use PPPOE, but good speed if use IPv6 (DHCP from ISP).
I need PPPOE to get a public IP address from my ISP, that's why I have to add a router in front of it.
Also I set one Raspberry pi as UNIFI controller, another one runs home assistant, so put them on the top.
This small rack for:
- 1 X UNIFI USG
- 1 X UNIFI 8 port switch
- 2 X Raspberry pi 3B+/4B
- 1 X ASUS AC68U/AC1900
What you need:
- You have to change your AC1900/AC68U router case which grated by bubbax: [Asus RT-AC68U Alternative Case] (https://www.thingiverse.com/thing:2870339)
- 8 X magnets 8mmx3mm
Video: https://youtu.be/oPL6XjQqQJU
Print instructions
Perimeter: 5 or more
Top & bottom layer: 0
Infill: 25% Grid