Dremel Workstation Soldering Iron Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to fit a Rothenberg Soldering Iron to a Dremel 220 Workstation, used for setting brass heat inserts.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 185
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was contemplating to modify my Dremel Workstation 220 to fit a soldering iron for a while. Luckily I found an existing model on Grabcad, which I modified to fit my Rothenberger soldering iron. In case the PLA is going to melt (even though there is a heat shield at the back of the iron), I probably will reprint in ASA.
I also created a locking flange to secure the soldering iron in place with two M5x30 bolts. Hex nuts were installed in the underside of the adapter. In a next iteration, I will add the nuts during the printing process in order to prevent them from falling out or replace them with heat inserts.
Finally I added some bushings so the bolts cannot be overtightened.