Redesigned LDM WASP Clay Extruder 3.0

This is a redesign of the blue Wasp extruder for clay. The original is prone to breaking, and manufacturer does not sell it as a separate piece. I redesigned it to be more robust. You can print it on any FDM printer from PET-G or PLA they both work just fine. All the files have thread tolerances but i still recommend that the first time you use any thread, screw and unscrew them a few times. You can also use some lubricant like WD40.

This extruder has also been redesigned so that you do not need to unscrew your extruder mount from your printer anymore. It also eliminates the need for 3 small screws on the bottom of your extruder. You simply tighten the nozzle and it holds the entire assembly fixed to your extruder mount.

A new extruder mount file is also included. I cut mine from 4mm plexiglass. You might have to adjust the hole position in the mount for different printers.

There are nozzles from 1-7 mm that can also be printed on FDM printers. Nozzles have no tolerances for holes so they are generally smaller when printed. I suggest redrilling them after printing to the right diameter. I made them in two versions and also included the bottom part with treads as a step or fusion file so you can design your nozzle on top of that.

Also included is the adapter for the original wasp nozzles and files for some nozzles that also fit on this adapter. They can also be printed on FDM printers.

Safehandler is for safely screwing nozzles to your extruder mount. I had a few incidents of cutting my fingers on sharp screws while tightening the nozzles.

And finaly there is a config bundle for prusa slicer for delta wasp 40100 if you have a smaller delta wasp 2040 just adjust the bead size and height under printer settings.

Settings are for 2 and 3 mm nozzles and some different print settings for vase or normal mode. I will upload the setings for bigger nozzles once I test them. Feel free to experiment with settings and give me some feedback.