Radio HT Tilted Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stand for HT radio that prevents it from falling over and allows it to be used while in stand
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 223
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This stand was created to support a variety of radios using the common battery slot on many HT radios and walkie talkies. Designed to support a radio on a flat surface and not fall over, enable it to be clearly viewed, allow operation of the radio while in stand and enable charging when possible.
The design was developed in FreeCAD using a parameters in FreeCAD spreadsheet. There were about 12 measurements that are entered for each radio model.
Feedback welcome.
Currently Supported Models
- Baofeng UV-5R
- Baofeng BF-888s
- Baofeng UV-S9PLUS
- Baofeng UV-82HP
- Anytone D878UVII
- Retevis RT-86
- Quansheng UV-K5
Optional Improvements
- Use sandpaper or small file to tweak fit. The design is intended to allow the stand to stay attached when picked up by the radio.
- Batteries might be slightly different shapes (like the Baofeng extra large battery). Again, a little sandpaper/file usually resolves the fit.
- Add non-slip material to the bottom for no-slick use
- Use enamel paint on the model on back of stand for easier viewing
- Use glow in the dark filament to help find it in the dark
Printing recommendations:
- Material: PLA, PETG - anything really
- Infill: 15% works
- Suggest Gyroid
- Suggest 3 layers but 2 will work
- Layer thickness: 0.20 mm / 0.25 mm (for faster printing)
- Supports are not needed